"Designer for a Day"  project created by Guest Designer Tammy Miller

Designer for a Day

Tammy Miller

Supplies used:
Distress Oxides in Black Soot, Aged Mahogany, and Wilted Violet.
MISTI stamping tool (not necessary, but extremely helpful)
Memento Tuxedo Black Ink
VersaMark Ink
Darice heat tool
Art Glitter glue
Ranger white embossing powder-recommend Nuvo Glacier White
White and black Neenah 65 lb cardstock
Vinnie’s Fav stamp set
Directions:
I used a Hero Arts Operation Write Home Year Round Sentiments for the sentiment stamp which Maymay does not offer in the store.
Taking a piece of white Neenah cardstock 4x5.25, start by marking off a 1.5 inch circle about halfway up the paper.  Blend the 3 colors of distress inks, starting with the Aged Mahogany, then the wilted violet, and finally the black soot until the desired look is achieved. With a baby wipe, drag lightly from the left and right side of the moon to get the streaks across the moon. Use a heat gun or allow to dry naturally until completely dry. Stamp the 3 trees on the right side of the paper using the black Memento ink. Using a MISTI or similar tool is helpful, but not necessary. Add small branches from the 4 stamps in the set until you get the desired look of the tree. Stamp the deer partially over the moon using black Memento (again, use the MISTI if desired).  Freehand cut a small piece of black cardstock to look like the ground (I started with a piece that was 1.5 x 4) and glue it to the stamped paper using Art Glitter Glue. I used my embossing buddy to treat the paper before stamping a sentiment in Versamark ink and heat embossing it with Ranger white using a heat tool. The final step is gluing the panel on an A2 size white card base (4.5x11 scored at 5.5).
Art glitter glueCardmakingDesigner for a day projectGuest designerHeat toolMemento inkMini mistiNuvo embossing powderVersamark inkVinnie's fav stamp set

1 comment

Cecilia Stein

Cecilia Stein

Beautiful card Tammy

Leave a comment

All comments are moderated before being published